A flexible and expandable autofrettage system for performing autofrettage on various components up to 12,000 bar. The system can be expanded by adding additional chambers and pressure intensifiers if the production ramps up. The ideal solution for ambitious manufacturing goals.

Universal Test Machine is suitable for machinery manufacturing,electronic appliances,automobile production,textile chemical fiber,wire and cable,packaging materials and other industries. Various tests such as tensile, compression, bending, shearing, peeling, tearing, and two-point extension (extensometers are required) are performed on materials or semi-finished products.

P.I.D self-adjusting mode and SSR control High Low Temperature Universal Testing Machine. Apply for tensile, compress, bending, peel, tearing, peeling, bursting, fatigue test on metal rod, metal plate, rubber, PU, leather, plastic, foam, sponge, water-proof material, cable, wire, fabric, nettle, non-woven, etc.

For static and cuasi-static test (low frequency fatigue) for high loads in many types of tests. Specially indicated to switch test mode, thanks to its dual space design. The choice of test mode tensile / compressive or tensile bending can be performed without switching devices, increasing the productivity.

Universal Testing Machine UNITEST M2 is a representative test equipment for physical properties. It is capable of measuring load, strength, elongation of products or materials such as rubber, film, plastic, metal, etc. Basically, Tests of fullering, tearing, compression, flexural, desquamation are available. Hardness (ILD, IFD), static load, repeat fatigue tests, the friction coefficient measurement test are also available.

The test rig has two chambers in which up to ten DUTs can be tested at an ambient temperature of -60°C up to 180°C simultaneously. 3 separate fluid circuits allow Glycol (coolant), oil, and water for example to be used as test fluids in one test bench and therefore offer a versatile test setup for any test lab.

High-pressure lines such as diesel injection lines (common rails) are autofrettaged for continuous use with pulsating pressure in series production. By applying the autofrettage process component service life can be increased by up to 30%.

This tester is designed to evaluate fatigue resistance by inducing fatigue in products or test samples, adhering to reliability testing requirements. It is designed and manufactured to meet customer requirements.

CRY2304 Noise and vibration analyzer is a new type of test instrument for noise and vibration analysis launched by CRYSOUND. The host uses USB 2.0 transmission protocol to communicate with the host computer, and supports synchronous input of noise and vibration signals with 4 channels. The analysis frequency range is 10 Hz - 80 kHz, and its noise floor is as low as -110 dBV, which is sufficient for high precision acquisition and high-quality analysis of noise and vibration in most cases.

This device is suitable for testing the bending or twisting ability of various wires and wire products. It is used to evaluate material properties and the fatigue strength of wires.

The temperature and humidity environment test chamber HUD-E702 is used in testing with electrical and electronic components and equipment, cars, aviation,...

This tester is a device to test the reliability of component materials and products. It is a device that checks the thermal characteristics of materials and products due to rapid temperature changes (within 5 minutes). Equipped with a high-performance cooler, the test temperature is reached quickly and noise and vibration are low. Additionally, various safety devices are built in to prevent malfunction.